A compact two-way reflex monitor, sold as a pair and hand-built in Europe: a silk-dome tweeter of 25 mm, a 130 mm glass-fibre woofer and an 8 ohm load, suited to amplifiers of 10 to 150 W.
Speaker Box 5 S2: how it is built
The cabinet is made of very rigid MDF with internal bracing, so the panels add no resonances of their own. Pro-Ject bonds it with a low-impact Kleiberit adhesive, chosen for its durability and to keep the enclosure airtight, which matters as much in a reflex design as the quality of the drive units.
The 25 mm tweeter uses a silk dome and a neodymium magnet; the 130 mm woofer has a glass-fibre cone. The crossover between them is wired point to point with no printed circuit board, and the solder is lead-free. Round the back you will find gold-plated terminals for single wiring.
With 88 dB sensitivity and a stated response of 55 Hz to 20 kHz, this is not a difficult speaker to drive. The maker suggests 10 to 150 W and points out that an amplifier with more in reserve runs with less distortion, whereas a small one pushed to its limit is exactly what can damage drive units. The front grille is held by magnets and is acoustically transparent; the model comes in several finishes.
Specifications
- Type: two-way standmount, reflex loaded
- Tweeter: 25 mm silk dome, neodymium magnet
- Woofer: 130 mm glass-fibre cone
- Frequency range: from 55 Hz up to 20 kHz
- Sensitivity: 88 dB at 1 W and 1 m
- Impedance: 8 ohms nominal
- Amplifier power: 10-150 W suggested
- Crossover: hard-wired, no circuit board
- Cabinet: internally braced MDF
- Terminals: gold-plated, single wiring
- Grilles: 2 supplied, magnetically fixed
- Size: 160 mm wide, 271 mm high, 215 mm deep
- Weight: 4.9 kg
- Supplied: sold as a pair
- Finishes: eucalyptus, walnut, black, white, green, yellow, red